Flow Toggle for valve

Build Help
#1

Prior to upgrading my flow toggle for my valve worked. User would authenticate, and the relay would trip, opening the valve. As far as I can remember this was automatic and required no config.

After the upgrade it appears you need to set this up in the “Controller” section manually.

What should be inputted in the “port name” in “Add Flow Toggle to Controller: kegboard”

Thanks!

#2

1001×367 36.5 KB

#3

nothing in the drop down like there was for “flow meter” or “temp sensor”

987×361 57.3 KB

#4

Sorry the UI is a little sucky here. For a DIY kegboard, it will understand toggles named relay0, relay1, relay2, relay3.

#5

Mike, What should the toggles be named for the KBPM when you get the firmware update ready?